Zoeller 57-0001 9 ft. Cord 0.33HP All Cast Iron Submersible Sump Pump with Vertical Float Switch
MSRP:
$326.63
$251.25
Features- Float-operated, submersible, 2-pole mechanical switch and variable level
- Corrosion-resistant, powder-coated epoxy finish
- No sheet metal parts to rust or corrode
- Stainless steel screws, switch arm, guard, and handle
- No screens to clog
- Watertight, neoprene square ring between motor and pump housing
- Solid, buoyant, polypropylene float
- Oil-filled, hermetically-sealed, automatic reset thermal overload protected motor
- Upper and lower sleeve Bearings running in bath of oil
- Entire unit pressure-tested after assembly
- Carbon and Ceramic shaft seal
- Maximum temperature for effluent or dewatering: 130 deg F (54 deg C)
- Passes 1/2" (13 mm) spherical solids
- 1-1/2" NPT discharge
- On point: 7-1/4" (18 cm)
- Off Point: 3" (8 cm)
- Major width: 10-3/32" (26.2 cm)
- Major Height: 10-1/16" (25.6 cm)
- Watertight and dust-tight
Specifications- Motor: 3/10 HP
- Voltage: 115 or 230 V
- Phase: 1 Ph
- Hertz: 60 Hz
- RPM: 1550 RPM
- Type: Shaded pole
- Insulation: Class B
- Amps: 4.8 - 9.7 Amps
- Operation: Automatic or nonautomatic
- Auto On / Off Points: 7-1/4" / 3" (18.4 cm / 7.6 cm)
- Discharge Size: 1-1/2" NPT
- Solids Handling: 1/2" (12 mm) spherical solids
- Cord Length: 9' (3 m) auto, 15' (5 m) nonauto
- Cord Type: UL listed, 3-wire cord and plug
- Max Head: 19.25' (5.9 m)
- Max Flow Rate: 43 GPM (163 LPM)
- Max Operating Temperature: 130 °F (54 °C)
- Cooling: Oil filled
- Motor Protection: Auto reset thermal overload
- Cap: Cast Iron or bronze
- Motor Housing: Cast Iron or bronze
- Pump Housing: Cast Iron or bronze
- Base: Cast Iron, bronze or engineered thermoplastic
- Upper Bearing: Sleeve Bearing
- Lower Bearing: Sleeve Bearing
- Mechanical Seals: Carbon and Ceramic
- Impeller Type: Non-clogging vortex
- Impeller: Plastic, Cast Iron or bronze
- Hardware: Stainless steel
- Motor Shaft: AISI 1215 cold roll steel
- Gasket: Neoprene
